← All glossary terms
Deformation Survey
A deformation survey compares two or more point clouds of the same structure captured at different times, to measure movement, settlement, or distortion.
Because every scan is registered against the same control network, two scans of the same structure taken months apart can be compared directly to quantify real movement, not scan-to-scan noise.
Where this is used
Frequently asked
Is Deformation Survey a separate service, or part of Scan to CAD/Model/BIM?
It's an application of our core services, not a separate offering — see the linked service page above for how Deformation Survey fits into Scan to CAD, Model, or BIM.
How long does a project involving Deformation Survey typically take?
It depends on site size and the specific deliverable level — see the linked service page's turnaround table for typical timing.
Does Deformation Survey require any special equipment beyond your standard setup?
No — the same Total Station + FARO capture used on every project applies here; Deformation Survey is a matter of how the output is scoped and drafted, not different hardware.
Can Deformation Survey be combined with another survey type on the same site visit?
Often yes — if your project needs Deformation Survey alongside another application, tell us during scoping and we'll plan a single capture that supports both.
Who should I talk to about a Deformation Survey project?
Start with the Contact page — describe the site and what Deformation Survey needs to achieve, and we'll scope it from there.